Specifications - Makita 6905B Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Side grip
3-1. Socket
3-2. Anvil

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model 6905B
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model 6906
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
4-1. Socket
4-2. O-ring
4-3. Pin
5-1. Limit mark
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Overall length
Net weight
Safety class
) : 93 dB(A)
pA
) : 104 dB(A)
WA
) : 98 dB(A)
pA
) : 109 dB(A)
WA
6905B
M12 - M20
M12 - M16
12.7 mm
1,700
2,000
294 N.m
270 mm
2.8 kg
ENE036-1
Model 6905B
Work mode : impact tightening of fasteners of the
ENF002-2
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model 6906
Work mode : impact tightening of fasteners of the
ENG905-1
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 2.0 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
6-1. Screwdriver
6-2. Brush holder cap
/II
) : 16.5 m/s
h
2
) : 16.5 m/s
h
2
6906
M16 - M22
M16 - M20
19 mm
1,700
1,600
588 N.m
327 mm
5.6 kg
/II
2
2
ENG901-1