Saeco New Royal HD 8930 Service Manual page 29

NEW ROYAL
Description of each page
SECTOR TYPE
DF FUNCTION
ER FUNCTION
Debug FUNCTION
FUNCTION
Swiss
FUNCTION
Pow Off
ESC FUNCTION
B2C INFO
B2B INFO
B2B RI INFO
MV: xx INFO
INFO
f
xx.yy.zz INFO
Saeco International Group
DF:64
B2C
f: xx Hz
Swiss
Provides information on the memory status. Must be 64
Provides information on the memory status. Must be 8
If selected, enables a debug window in user mode
The Swiss function is used to enable or disable the ECO-MODE default setting. If Swiss is enabled,
the default for the Eco-Mode is "ON", if Swiss is disabled the default for the Eco-Mode is "OFF".
The water circuit emptying function restores the ECOMODE value to the default value. As stated
above, the default value depends on the Swiss setting.
Indicates whether the machine will go to Stand-By mode when powered up - main electro-mechan-
ical switch (I/O) on, if this occurs the words "Pow Off" are highlighted. If it is disabled, the machine
will not go to Stand-By mode straight after Power On.
If pressed, it exits the Test mode.
If activated, it indicates that the machine version is B2C.
If activated, it indicates that the machine version is B2B.
If activated, it indicates that the machine version is B2B with mains water.
Indicates the version of the EEPROM Memory
Indicates the mains frequency. It has the following values:
50 Hz
60 Hz
ERR if the frequency cannot be detected.
Indicates the version of the loaded software.
For Saeco parts, repairs & tech support, contact:
Services Unlimited, Inc./ Parts Guru
209 Walnut street, Lansdale, PA 19446
215-361-7000 - email: sales@partsguru.com
Online store: www.shop.partsguru.com
1 Software
1 Software
ER:8 Debug
B2B B2B RI MV: xx
xx.yy.zz
*
Pow Off ESC
DESCRIPTION
Rev. 01
05 TROUBLESHOOTING
Page
02
/ 07