Russound CAS44 Service Manual page 64

Repeat procedures for Zones 2 through 6
The last few items listed below are repeated procedure to test zone 2 through 6.
1. Turn off the CAS44 by pressing the power button on the front panel.
2. Move the KP4 to the next Keypad Port.
Move the speaker to the same numbered port your keypad is connected to.
3. Turn on the CAS44 by pressing the power button on the front panel.
4. Repeat the process of testing each Zone by repeating the following sections:
***The Source and IR Selection Test,
the Treble, Bass, Balance, and Loudness Test,
and the Front Panel LED, Trigger Out, and Page Mute Test
The only difference is
When the KP4 is in Keypad Port 1 the Speakers are in Port 1
When the KP4 is in Keypad Port 2 the Speakers are in Port 2
When the KP4 is in Keypad Port 3 the Speakers are in Port 3
When the KP4 is in Keypad Port 4 the Speakers are in Port 4
5. You must test each keypad port before proceeding to the next page of the test
procedure.
CAS44 Test Procedure
July 22, 2005
23 of 26