Routine Cleaning; Cleaning The Platen Glass And Underside Of The Feeder; Manual Feeder Cleaning - Canon imageRUNNER ADVANCE C9280 PRO User Manual

Routine Cleaning

If the original is not copied clearly, clean the following
parts of the machine. For high-quality printouts, we
recommend cleaning these parts once or twice a
month.
● Platen glass
● Underside of the feeder
● Wires
● Rollers
● Drums
If the touch panel display becomes dirty and the screen
may not be seen clearly, clean the touch panel display. Since
the touch panel display becomes dirty from normal use, we
recommend that you clean it once a week or every 10 days.
•
When cleaning the machine, fi rst turn OFF the
main power switch, and disconnect the power cord.
Failure to observe these steps may result in a fi re or
electrical shock.
•
Disconnect the power cord from the power outlet
regularly, and clean the area around the base of
the power plug's metal pins and the power outlet
with a dry cloth to ensure that all dust and grime is
removed. If the power cord is connected for a long
period of time in a damp, dusty, or smoky location,
dust can build up around the power plug and
become damp. This may cause a short circuit and
result in a fi re.
IMPORTANT
•
When cleaning with a cloth, do not dampen it too
much, as this may damage the original or break the
machine.
•
Do not use alcohol, benzene, paint thinner, or other
solvents for cleaning. Doing so may result in damage to
the plastic parts.
NOTE
The Duplex Color Image Reader Unit-F1 is an optional
product.
3
Downloaded from ManualsPrinter.com Manuals
Cleaning the Platen Glass and
Underside of the Feeder
If the platen glass or the underside of the feeder is dirty,
the original may not be scanned clearly, or the size of the
original may be detected incorrectly. Clean the platen
glass and the underside of the feeder by following the
procedure below.
NOTE
This procedure is necessary only if the Duplex Color
Image Reader Unit-F1 is attached.
1
Clean the platen glass and the underside
of the feeder with a cloth which is wrung
after being dampened in water or a mild
detergent, and then wipe them clean with a
soft, dry cloth.
1. Clean the platen glass.
2. Clean the underside of the feeder.

Manual Feeder Cleaning

If originals that have been fed through the feeder have
streaks or appear dirty, clean the feeder's scanning area.
Clean the feeder's scanning area with a cloth which is
wrung after being dampened in water, and then wipe
them clean with a soft, dry cloth.
IMPORTANT
If the document feed scanning area is dirty, documents
may not be scanned clearly, and the size of the document
may not be detected correctly.
NOTE
This procedure is necessary only if the Duplex Color
Image Reader Unit-F1 is attached.
1
Clean the original scanning area (thin glass
strip).
1. Open the feeder.
2. Clean the original scanning area (thin glass strip) with a
cloth dampened in water, and then wipe the area with
a soft dry cloth.
Routine Maintenance 57