Electrical Connection; Hard Wire Connection - Viking VDSC305 Service Manual

ELECTRICAL CONNECTION

Use a 3 - wire power supply cord kit rated for 30 amps - 125/250 volts
for Models VDSC and VERT or 50 amps - 240 volts for Model VESC
with closed loop terminals and marked for use with ranges. Where local
codes do not permit grounding through neutral, use a 4 - wire power supply
cord. The cord or conduit must be secured to the range with the strain relief
bracket. The electrical connection is made at the terminal block, which is
located behind the access door on the back of the range.
3 - Wire Power Supply Cord
1. Remove access door.
2. Remove supply cord strain relief bracket and 3 supply cord mounting
screws on the terminal block.
3. Feed supply cord up through the hole in the bottom of range back.
4. Attach the line #1 (red) and line #2 (black) leads to the outside
terminals and the neutral wire (white) to the center terminal on the
terminal block.
5. Reattach supply cord strain relief bracket over supply cord, pushing
supply cord up toward terminal block to relieve strain before
tightening.
6. Reattach access door.
4 - Wire Power Supply Cord
1. Remove access door.
2. Remove supply cord strain relief bracket and 3 supply cord mounting
screws on the terminal block.
3. Remove grounding screw; cut-off and discard ground strap.
4. Feed supply cord up through hole in the bottom of the range back.
5. Attach the ground lead (green) with the ground screw that was
removed in step #3.
6. Attach the line #1 (red) and line #2 (black) leads to the outside
terminals and the neutral wire (white) to the center terminal on
the terminal block..
7. Reattach supply cord strain relief bracket over supply cord,
pushing supply cord up towards terminal block to relieve strain
before tightening.
8. Reattach access door.
22