Philips RQ1285CC User Manual page 66

English
Problem
The Jet Clean
System does not
work when I
press the on/off
button.
The shaver is
not fully charged
after I charge it
in the charger/
Jet Clean
System.
Possible cause
The cleaning fluid level is
too low. If the fluid volume
in the cleaning chamber
drops below the minimum
level during the cleaning
program, the program
aborts.The cleaning light and
the 'cleaning chamber empty'
symbol flash at intervals and
the holder returns to its
starting position.
You have used another
cleaning fluid than the
original Philips cleaning fluid.
The Jet Clean System is not
connected to the mains.
You have not placed the
shaver in the Jet Clean
System properly, so there
is no electrical connection
between the Jet Clean
System and the shaver.
You have not placed the
shaver in the charger/Jet
Clean System (specific types
only) properly.
65
Solution
Refill the cleaning
chamber with
cleaning fluid to
a level between
the two lines (see
chapter 'Cleaning and
maintenance').
Only use HQ200
Philips Cleaning Fluid.
Put the small plug in
the Jet Clean System
and put the adapter
in the wall socket.
Press the shaver
tightly into the
holder to lock it into
place.
Make sure you press
the shaver until it
locks into place.