Table of Contents
Advertisement
Technical Specifications and Safety Information A-5
47CFR Part 68 Information
FCC Requirements
1.
The Federal Communications Commission (FCC) has established Rules which permit this device to be
directly connected to the telephone network. Standardized jacks are used for these connections. This
equipment should not be used on party lines or coin phones.
2.
If this device is malfunctioning, it may also be causing harm to the telephone network; this device should
be disconnected until the source of the problem can be determined and until repair has been made. If this
is not done, the telephone company may temporarily disconnect service.
3.
The telephone company may make changes in its technical operations and procedures; if such changes
affect the compatibility or use of this device, the telephone company is required to give adequate notice of
the changes. You will be advised of your right to file a complaint with the FCC.
4.
If the telephone company requests information on what equipment is connected to their lines, inform them
of:
a. The telephone number to which this unit is connected.
b. The ringer equivalence number. [0.XB]
c. The USOC jack required. [RJ11C]
d. The FCC Registration Number. [XXXUSA-XXXXX-XX-E]
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN) is used to determine
how many devices can be connected to your telephone line. In most areas, the sum of the REN's of all
devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring
properly.
FCC Statements
a) This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
b) List all applicable certification jack Universal Service Order Codes ("USOC") for the equipment: RJ11.
c) A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is
also compliant. See installation instructions for details.
d) The REN is used to determine the number of devices that may be connected to a telephone line. Excessive
RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not
all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the local telephone company. For products
approved after July 23, 2002, the REN for this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3).
For earlier products, the REN is separately shown on the label.
Advertisement
Table of Contents
