Epson EPL-N2500 Quick Reference Manual page 7

Need Memory
The printer has insufficient memory to
complete the current print job. Cancel
printing by deleting it from the print queue
on your computer, or by pressing the
Cancel Job button on the printer.
To clear this error message, select Clear
Warning from the control panel's Reset
Menu. See "How to access the control panel
menus" for instructions.
To prevent this problem from happening
again, add more memory to your printer as
described in the Reference Guide.
Offline
The printer is not ready to print. Press the N
Start/Stop button .
Optional RAM Error
The optional memory module may be
corrupted or incorrect. Replace it with a new
one.
Paper Out XXXXX YYYY
There is no paper in the specified paper
source (XXXXX). Load paper of the indicated
size (YYYY) into the paper source.
Paper Set XXXXX YYYY
The paper loaded in the specified paper
source (XXXXX) does not match the required
paper size (YYYY). Replace the loaded paper
with the correct size paper and press the N
Start/Stop button to resume printing. Or
press the Cancel Job button to cancel the
print job.
If you press the N Start/Stop button without
replacing the paper, the printer will print on
the loaded paper even though it does not
match the required size.
EPSON EPL-N2500 Quick Reference
Printer Open
One or more of the following covers are
open; Cover A or Cover B.
Print Overrun
The required time to process the print data
exceeded the print engine speed because the
current page is too complex. Press the N
Start/Stop button to resume printing. Or
press the Cancel Job button to cancel the
print job. If this message appears again,
select On as the Page Protect setting in the
control panel's Setup Menu.
If you continue to receive this message when
printing a particular page, try simplifying
the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the
printer as described in the Reference Guide.
RAM Check
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Toner
The toner has run out.
Install a new imaging cartridge. See the
Reference Guide for instructions.
This error is not displayed when the Toner
Out setting is set to Continue in the control
panel setting. When the Toner Out setting is
set to Continue, replace the imaging
cartridge if the printout is light or faint.
Status and Error Messages (4/5)