Installing With Base; Before You Install; Adjusting The Recline Angle; Recline Angle Indicators - Britax B-SAFE User Manual

Installing with Base

Before You Install

Adjusting the Recline
Angle
• To adjust the recline angle of
the base, hold in the recline
adjustment button on the recline
adjustment foot and move the foot
up or down.
• Correct recline angle is acheived
when the green markers on
the recline angle indicators are
visible between the two lines (see
next page).
• If there is a problem achieving
the appropriate recline angle after
following the previous steps:
* Try another approved seating
position in your vehicle
* Uninstall the base and lower
the recline angle adjustment
foot to the lowest position.
* Remove the base from the
vehicle.
* Place a rolled towel or pool
noodle in the vehicle seat
bight.
* Place the base on the towel(s)
or pool noodle(s) to acheive
the appropriate recline angle
for the base.
NOTE: If towel(s) or pool noodle(s) is
needed to acheive appropriate recline
angle, the recline angle adjustment
foot on the base should remain in its
lowest position.
12

Recline Angle Indicators

• Correct recline angle is acheived when the green markers on
the recline angle indicators are visible between the two lines.
• Vehicle must be parked on a level surface.
Lower Connectors
• Push and hold the lower
connector release button
to remove the lower
connectors from the
storage slot in the base
or from the seat when
installed.
• To store the lower
connectors, push the lower
connector into the storage
slot in the base until they
click into place.
NOTE:
* Lower connectors should
always be stored in the
base when not in use.
Installing with Base
13