Lcs Installation - Britax B-SAFE User Manual

Installing with Base

LCS Installation

WARNING!
• Only raise the base as described in these instructions. Do not use
anything to raise the base of the infant car seat off the front edge of the
vehicle seat. In a crash, this could cause the infant car seat not to perform
as intended.
• For LCS installation, the base must be secured in the vehicle before
attaching the occupied infant car seat.
• Use either the LCS or a vehicle belt methods to install this child seat.
Using both is not approved and may cause the child seat not to perform
as intended.
• Verify that your vehicle is
equipped with lower anchors.
• Remove lower connectors
from the storage slots on the
base by pressing the red
button and pulling outward.
• Press and hold the lower
connector adjuster release
button and pull to lengthen the
strap.
14
• Place the base in the desired
location on the seat and press
the lower connectors onto the
adjacent LUAS anchors until a
click is heard.
NOTE: Pull the lower connector to verify
that it is secure.
• While pressing the base down
into the seat, pull up on the
LCS adjuster strap to tighten.
• Open the two portions of the
lock-off and route the excess
LCS strap webbing through.
• Close the top portion and then
the bottom portion of the lock-
off to secure excess webbing.
NOTE: Excess webbing can interfere
with the infant car seat connecting
correctly with the base. Excess webbing
should always be stored.
• Verify that the LCS strap is tight and that the base is secure.
The base is secure when it moves less than 2.5 cm (1 in.) front-
to-back or side-to-side at the vehicle belt path.
• Correct recline angle is acheived when the green markers on
the recline angle indicators are visible between the two lines.
Installing with Base
15