Printable Area And Media Size Checking - Epson SureColor S40600 User Manual

• If white bands (pale stripes) appear in your printouts, press the down arrow button to decrease the
feed amount.
3. Check your printout for banding and repeat these steps as necessary.
Parent topic:

Printable Area and Media Size Checking

The left and right edges of media recognized by your product vary depending on the Media Size Check
setting.
• When the Media Size Check setting is turned on, your product automatically detects the left and right
edges of the media within 0.2 inch (5 mm), as long as the media holding plates are attached correctly.
• When the Media Size Check setting is turned off, your product uses the longest scale on the after
heater label shown here as the standard position for the right edge of the media. The left edge of the
media is determined to be 64 inches (1626 mm) from the standard position for the right edge, no
matter the width of the loaded media. The printable area ranges for the media are described in the
table here.
Note: If you turn off the Media Size Check setting, printing may occur outside the edges of your
media, causing ink to stain the product. Make sure your print data width does not exceed the loaded
media width. When you load media to the left of the right side reference position, adjust the Print Start
Position setting on the product control panel to match the position where the media is loaded.
Tasks You Can Perform While Printing
62