Epson SureColor S40600 User Manual page 139

LCD screen message
Warming Up...
Force to start printing
Command Error
Check print settings on RIP.
Clogged nozzles detected.
Cleaning recommended.
F/W Install Error
Firmware update failed.
Restart the printer.
Print head is nearing end of
service life.
Auto Take-up Reel Unit stopped. Press the
Media Size Error
Load correct size media.
Solution
One or more heaters is warming up to the specified temperature. To
start printing without waiting for the heater to warm up, press the OK
button.
Press the pause/cancel button and select Job Cancel. Make
sure the installed RIP software is compatible with the product.
Perform head cleaning if necessary.
Turn off the product, wait a few minutes, and turn it on again. Then
reinstall the firmware again.
If this message persists, contact Epson for support.
The print head is nearing the end of its service life. Contact Epson
for support.
pause/cancel button and select Job Cancel to cancel
printing. Then set the Auto switch on the auto take-up reel to the off
position, set it back to the original position, and reattach the media to
the auto take-up reel.
Raise the media loading lever and remove the currently loaded
media. Be sure the media is at least 11.8 inches (300 mm) wide.
If this message appears even when the media is the correct width,
turn off the Media Size Check setting and try printing again.
139