Top Panel - NETGEAR WNDR3300f Setup Manual

The back of the wireless router includes:
Four local (LAN) 10/100 Mbps Ethernet ports for connecting the router to local computers
1.
Internet (WAN) Ethernet port for connecting the router to a cable or DSL modem
2.
Restore factory settings button
3.
AC power adapter outlet
4.

Top Panel

Figure 4
The top of the wireless router includes a dome that performs two functions:
1. Antenna display lights. The lights identify the activity of the eight internal antennas, flashing
to show which combination of antennas is receiving the strongest signals. These status lights
are off by default but can be turned on.
2. Push 'N' Connect (WPS). The dome acts as a push-button for the router to enable WPS
security with other WPS-enabled devices. Pushing on the dome for over 5 seconds opens a 2-
minute window for the router to connect with other WPS-enabled devices.
Before using these WiFi Protected Setup (WPS) push-button procedures, verify
that your device (a notebook, adapter, or other device) supports WPS.
To use the WPS method to implement security, see
Configure Your Wireless Network" on page
Getting to Know Your Wireless Router
Wireless Router Setup Manual
"Using Push 'N' Connect (WPS) to
23.
5