Opening The Rails - IBM x3850 X6 Installation Instructions Manual

4. Repeat steps 2 on page 5 and 3 on page 7 for the rear of the rack. Make sure

Opening the rails

This topic provides information about how to open the rails to install them in the
rack.
About this task
Note: These instructions apply to both the 4U and the 8U server models. Only the
4U is shown in the illustrations.
To open the rails, complete the following steps:
1. Retract both rails, if they are not already retracted. Grasp the rails on both ends
8
System x3850 X6 and x3950 X6 Types 3837 and 3839: Rack Installation Instructions
that a cage nut or clip nut is installed in every hole indicated on the template.
and push the rails in until they are fully retracted.
Note: Rail posts and locking hooks are on the ends of each rail.