Cleaning Beater Bar; Cleaning Exterior And Tools - Panasonic mc-ul592 Service Manual

CLEANING BEATER BAR

CLEANING EXTERIOR AND TOOLS

Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquird detergent and water and wrung dry.
DO NOT drip water on the vacuum cleaner and wipe dry after cleaning.
DO NOT clean tools in dishwasher or clothes washer.
Wash tools in warm soapy water, rinse and air dry.
DO NOT use tools if they are wet.
Loop new belt around motor shaft and beater bar belt groove.
Reinstall beater bar by inserting the end cap of the beater bar to the slot
for both side.
After reinstalling the beater bar, turn it by hand to make sure that the belt is
not twisted of pinched and that all rotating parts turn freely.
Reinstall lower plate. See "Removing and Installing Lower Plate".
Clean beater bar for Nozzle and Mini Turbine Nozzle after every five uses.
Turn vacuum cleaner over, exposing the beater bar for Nozzle.
Cut off any carpet pile and lint entangled around beater bar for Nozzle
and Mini Turbine Nozzle with a pair of scissors.
7