Me101 802.11B Wireless Ethernet Bridge Lights; Restoring The Bridge To The Default Settings - NETGEAR ME101 User Manual

ME101 802.11b Wireless Ethernet Bridge
Lights and Settings

ME101 802.11b Wireless Ethernet Bridge Lights

The ME101 802.11b Wireless Ethernet Bridge has the following three lights, which give you
feedback on the status of your wireless connection:
PWR
WLAN
LAN

Restoring the Bridge to the Default Settings

There are three ways to return the bridge to its default factory settings.
• Press the Default button with the point of a pen or pencil for at least 6 seconds and then
release the button. This reboots the ME101 and reverts all the current settings to the
factory defaults.
1. Press the Default button with the point of a pen or pencil as you power the bridge back
on until the LAN
2. Release the Default button.
3. Press and hold the Default button again.
Both the LAN
4. Release the Default button after both lights flash quickly.
1. Open and log into the browser-based configuration software.
2. Click Restore Factory Default.
3. Click Restore.
4. Click Logout.
Green OFF: No power to the unit.
ON: Power applied to the unit.
Green OFF: No wireless LAN activity.
Flashing: Searching for an access point or wireless router.
ON: Connected to a wireless LAN.
Green OFF: No Ethernet traffic.
Flashing: Wired Ethernet traffic.
ON: Connected to the Ethernet.
and WLAN
and WLAN
lights both flash.
lights should flash slowly.
14