Panasonic CF-T1 Reference Manual page 67

Dealing with Problems (Advanced)
G
Display (continued)
The screen becomes
disordered
The external display no longer
displays properly
During simultaneous display,
the screen of the external
display becomes disordered
The screen does not fill up the
entire display (i.e., the screen is
shown in the center of the
display)
When an MPEG file is being
played with Media Player, the
display destination cannot be
switched using Fn Fn + F3 F3
Fn Fn F3 F3
For Hong Kong For Hong Kong For Hong Kong For Hong Kong
Application is not displayed
properly, or characters are
garbled
G
Setup Utility
[Enter Password] is displayed
[Advanced] and [Boot] menu
can not be registered
Some items in [Security] menu
can not be registered
F9 does not work F9 F9 F9
G
Shutting Down
Windows cannot be shut down
or restarted
G
Standby/Hibernation Function
Unable to enter standby or
hibernation mode
The computer does not resume
G
Changing the number of colors or resolution of the display may affect the screen.
Restart the computer.
G
When an external display not compatible with the power saving mode is used with
the computer, the external display may no longer display properly when the
computer enters the condition the power of the display is off (for energy
conservation purposes). In such cases, turn off the power to the external display.
G Try switching the display destination by pressing Fn + F3 .
G
If the screen of external display is not displayed even after switching screens using
Fn + F3 , try switching the display destination using the following procedure:
Windows 2000
[Start] - [Settings] - [Control Panel] - [Intel® Extreme Graphics]
Windows XP
[start] - [Control Panel] - [Other Control Panel Options] - [Intel® Extreme Graphics]
G
If the screen resolution is set to 800 x 600 or less and the screen is set to
simultaneous display, the screen will not fill up the entire display. Also, if the screen
is set to Extended Desktop, the screen may not fill up the entire display.
G
The display destination cannot be switched while an MPEG file is playing.
Stop playing the MPEG file before switching the display destination.
G
Is the application a non-Unicode program? When non-Unicode programs are run
on Windows XP, you must select the language appropriate to that program.
Set [Language for non-Unicode programs] in [Control Panel] - [Date, Time,
Language, and Regional Options] - [Regional and Language Options] - [Advanced].
G
Enter the User Password or Supervisor Password. If you have forgotten it, contact
your technical support office.
G
Restart the Setup Utility with the Supervisor Password.
G
Restart the Setup Utility with the Supervisor Password.
G
Restart the Setup Utility with the Supervisor Password.
G
If a USB device is connected, try removing it.
G
If a USB device is connected to the computer (note: only for some USB devices),
remove the USB device temporarily. If the problem persists, restart the computer.
G
Did you slide the power switch and hold it for four seconds or more?
If you slide the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
67