Panasonic CF-T1 Reference Manual page 20

Security Measures
Setting the Supervisor Password (enabling, changing, disabling)
NOTE
G
When [Password on boot] in the Setup Utility is set to [Disable], the password is not
necessary when the computer is started up, but the password becomes necessary
when the Setup Utility is started up. This alternative makes it possible to prevent the
contents of the Setup Utility from being changed.
1
Run the Setup Utility.
2
Using either Î Î Î or Í Î
3
Using either Ï Ï or Ð Ï Ï
press Enter Enter Enter. Enter
4
<Only when the Supervisor Password has been set>
Enter your password at [Enter Current Password] and press
Enter Enter Enter Enter.
5
Enter your password at [Enter New Password] and press Enter
GTo disable the Supervisor Password
Press only Enter .
6
Re-enter your password at [Confirm New Password] and press
Enter Enter.
Enter Enter
G To disable the Supervisor Password
Press only Enter .
7
At [Setup Notice], press Enter
8
Press F10 F10 F10 F10 and select [Yes], then press Enter
NOTE
G
Your password will not be displayed on the screen.
G
Limit your password to seven characters. Note that there is no distinction between
upper and lower case letters.
G Do not input your password while holding down on Shift or Ctrl .
G
Use only the upper horizontal row of numeric keys to input your password.
G
Only the alphabet keys or number keys can be used. Note that the space bar and
function keys cannot be used.
G
Disabling the Supervisor Password also disables the User Password.
CAUTION
G
Do not forget your password. If your Supervisor Password is forgotten you will be
unable to use your computer. Contact your technical support office.
G
When running the Setup Utility, do not leave your computer even for a short time, as
the possibility exists for the password to be set/changed by another person.
(Ÿ page 54)
Í , select [Security]. Í Í
Ð , select [Set Supervisor Password] and Ð Ð
Enter. Enter Enter
Enter.
Enter Enter
Enter. Enter Enter
20