Engine Oil Pan - Remove And Install - Perkins 1103 Disassembly And Assembly

104
Disassembly and Assembly Section
End By:
a. Install the camshaft. Refer to this Disassembly
and Assembly Manual, "Camshaft - Remove and
Install".
Engine Oil Pan - Remove and
Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Note: Ensure that the engine oil pan is fully supported
before the oil pan is removed. Particular care must
be taken with the cast iron version of the engine oil
sump as this version is heavy.
Illustration 231
1. Remove all dirt, oil, and grease from the exterior
surfaces of the oil pan (5).
2. Operate the engine until the engine is warm. Stop
the engine.
3. If necessary, remove the nut (2), the seal, and the
i01958105
tube assembly from the engine oil pan (5).
4. Remove the oil drain plug (6) and the O-ring.
Drain the engine oil into a suitable container for
storage or disposal.
5. Remove the setscrews (3) and the setscrews (4)
from the engine oil pan (5).
6. Remove engine oil pan (5) and remove the joint
(1) from the cylinder block. Discard the joint (1).
7. Clean the engine oil pan (5) with a suitable
cleaning fluid. Ensure that all of the cleaning fluid
is removed.
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: If the bridge for the cylinder block and/or the
timing case have just been installed the engine oil
pan must be installed before the silicon sealant has
cured.
Note: Ensure that any old silicon rubber sealant is
removed from the mating surfaces of the engine oil
pan when the sump is installed.
1. Clean the flange face of the engine oil pan (5) and
the flange face of the cylinder block.
g01042307
SENR9779-02
NOTICE