11.
Click [Go to Trigger page].
•
The Trigger page is displayed.
Note
•
If you set a short interval to transfer image to a cell phone, many E-mails
may be sent to it leading to a large phone bill. Therefore, we recommend
you to set a long interval. 1 image per minute frequency is recommended.
•
Motion Detection transfer stops its operations until the camera finishes all
transfers. For example, if the camera transfers 3 images per minute and 6
images in total, the Motion Detection will be in the following operation.
Detectable
A Motion Detection signal is detected.
•
If you are buffering images on the internal memory, the following
operations also delete all buffered images.
–
Turning off the camera.
–
Saving the Date and Time page.
–
Restarting, updating firmware or resetting the camera to factory
default.
–
Maximum number of buffered images change depending on
resolution, image quality and what object the camera buffers. At the
320 x 240 pixels resolution and the standard quality, the camera
buffers about 125 frames. (If 3 triggers are enabled [maximum 5
triggers], the internal memory capacity is divided into 3 sections. In
this case, each trigger can buffer about 40 images.) See "3.11 File
Size and Number of Buffered Images" on the Operating Instructions
for the internal memory capacity.
Note
•
A change due to light or wind may detect motions mistakenly.
•
Motion detection level is changed depending on resolution, image quality,
and object situation. Confirm the level by performing motion detection
recording.
•
Enabling Motion Detection delays the frame rate of the camera.
•
Objects moving fast may not be detected.
•
Motion Detection may not work in the dark.
120 seconds
1st
2nd 3rd
Undetectable
[For assistance, please call: 1-800-272-7033]
Operating Instructions (Additional Features)
4th
5th
6th
Detectable
39