Installation And Commissioning; Installation; Adjusting The Table Height - Pfaff 333-712/02 Instruction Manual

Installation and commissioning

8 Installation and commissioning
8

Installation

.01
The site where the machine is installed must be provided with suitable connections for
electric current and compressed air. It must be ensured that the standing surface of the
machine site is firm and horizontal and that sufficient lighting is available.
8

Adjusting the table height

.01.01
● Loosen screws 1 and 2 and set the table at the required height.
● Fully tighten screw 1.
● Set the required pedal position and tighten tighten screw 2.
8 - 1
The machine must only be installed and commissioned by qualified personnel!
All relevant safety regulations must be strictly adhered to!
If the machine is delivered without a table, be sure to use a stand and table that
will reliably support the weight of the machine with its motor.
It is very important to ensure that the stand of the machine is firm and steady,
also during sewing.
For packing and transportation reasons the table top is in the lowered position.
The table height is adjuted as described below.
1
Fig. 8 - 01
2
1