Installation And Commissioning; Installation; Adjusting The Table Height - Pfaff 422 Instruction Manual

Installation and commissioning

8 Installation and commissioning
8

Installation

.01
The site where the machine is installed must be provided with suitable connections for elec-
tric current.
It must be ensured that the standing surface of the machine site is firm and horizontal, and
that sufficient lighting is provided for.
8

Adjusting the table height

.01.01
8 - 1
The machine must only be installed and commissioned by qualified personnel!
All relevant safety regulations must be strictly adhered to!
If the machine is delivered without a table, be sure to use a stand and table
top that can hold the weight of the machine with its motor.
It is very important to ensure that the stand of the machine is firm and steady,
also during sewing.
For packing and transportation reasons the table top is in the lowered position.
The table height is adjusted as described below.
1
Fig. 8 - 01
Loosen screws 1 and 2 and set the table height as required.
Firmly tighten screw 1.
Set the required pedal position and tighten screw 2.
2
1