Snapshot - D-Link DCS-6815 User Manual

Section 3 - Configuration
In order to enable your camera to take snapshots, you must select the checkbox of Enable snapshot. Then, you cna determine the trigger
event(s) email notification(s).
Enable Snapshot Tick this checkbox to enable snapshots.
Trigger By: You may choose to trigger snapshots by motion detection or
D/I signal.
Remote SMTP
Setup: You must configure the SMTP server that you will use to
e-mail snapshots.
Auth User: This is the SMTP username. Sometimes, this field requires
a full e-mail address.
Auth Password: This is the pathword associated with the username above.
SMTP Server: This is the address of the SMTP server. You may enter an IP
address or a DNS address.
Sender's Email: This is the e-mail address that the mail will appear to be sent
from.
Recipient's Email: This is the e-mail address that the mail will be sent to.
SMTP Port: This is the SMTP port that the server runs on. The default
value is 25.
D-Link DCS-6815 User Manual

Snapshot

36