To Change The Octave Of Each Layer - Casio celviano ap-700 User Manual

To change the octave of each layer

You can use the procedure below to change the octave
of each layer.
1.
Hold down the cnLAYER button until the
screen shown below appears.
2.
Use the clw and q arrow buttons to
select the layer whose octave you want to
change.
• Upper 1: Select "Upper1 Octave"
Upper 2: Select "Upper2 Octave".
3.
Use the clu (–) and i (+) arrow buttons to
change the octave.
• +1 or higher: Raises the octave by the specified value.
–1 or lower: Lowers the octave by the specified value.
0: Returns the octave to its original setting.
• The setting range is –2 to +2.
4.
To return to the screen you were at prior to
step 1 of this procedure, press ckEXIT
button.
Splitting the Keyboard
between Two Different Tones
You can use the procedure below to assign different
tones to the right range and left range of the keyboard,
so it sounds like you are playing an ensemble between
two instruments.
Split point
Acoustic Bass
F # 3
• If you turn on both layer and split, layering will be
applied to the right side range of the keyboard only.
• Use of the Duet Mode (page EN-14) is recommended
to divide the keyboard in the center between a left
keyboard and right keyboard of identical ranges.
1.
Press the cnLAYER button.
2.
Use the clu and i buttons to display
"SPLIT".
• To use both keyboard split and keyboard layering,
display "LAYER&SPLIT".
3.
Select a tone for the left keyboard.
• Use the clw and q arrow buttons to select "L"
(Lower) and then press the cmENTER button.
L
4.
Select a tone and then press the cmENTER
button.
• See "Selecting and Playing a Tone" on page EN-10 for
information about how to select a tone.
Playing with Different Tones
Berlin Grand
EN-17