Layering Two Tones; To Adjust The Volume Balance Between; Two Layered Tones - Casio celviano ap-700 User Manual

Playing with Different Tones

Layering Two Tones

Use the following procedure to layer two tones, so they
sound at the same time.
1.
Press the cnLAYER button.
2.
Use the clu and i arrow buttons to
display "LAYER".
3.
Select the main tone.
• Use the clw and q arrow buttons to select "U1"
(Upper 1) and then press the cmENTER button.
U 1
4.
Select a tone and then press the cmENTER
button.
• See "Selecting and Playing a Tone" on page EN-10 for
information about how to select a tone.
5.
Select the layered tone.
• Use the clw and q arrow buttons to select "U2"
(Upper 2) and then press the cmENTER button.
U 2
6.
Select a tone and then press the cmENTER
button.
7.
Press a keyboard key.
• Both tones sound at the same time.
EN-16
8.
To cancel layering and switch to a single tone
(Upper 1), press the cnLAYER button or
ckEXIT button.
• Each press of the cnLAYER button toggles between
unlayered (one tone) and layered (two tones).
• Two tone output is enabled while the cnLAYER
button lamp is lit.
• Entering the Duet Mode (page EN-14) or Duet Pan
Mode will disable layering.
• Configuring of layering settings is not supported by
MIDI Recorder Track 2 recording.

To adjust the volume balance between

two layered tones

1.
Hold down the cnLAYER button until the
screen shown below appears.
2.
Use the clw and q arrow buttons to
select "Layer Balance".
L a y e r B a l a n c e
3.
Use the clu (–) and i (+) arrow buttons to
adjust the layer volume balance.
• –1 or lower: Increases the Upper 1 tone volume.
+1 or higher: Increases the Upper 2 tone volume.
0: Upper 1 and Upper 2 volume the same.
• The setting range is –24 to +24.
4.
To return to the screen you were at prior to
step 1 of this procedure, press ckEXIT
button.