Start Up; Safety Valve; Refill Fuel - Kärcher HDS 801 D Instruction Manual

Overflow valve
If the hand spray gun is closed, the
–
overflow valve opens and the high pres-
sure pump diverts the water back to the
pump suction side. Thus the permissi-
ble working pressure is not exceeded.
The overflow valve is set by the manu-
–
facturer and sealed. Setting only by
customer service.

Safety valve

The safety valve opens when the over-
–
flow valve is defective.
The safety valve is set by the manufac-
–
turer and sealed. Setting only by cus-
tomer service.
Thermo-valve at the pump
The thermo-valve opens when the permis-
sible water temperature is exceeded and
lets out the hot water into the open.
Pressure switch
The pressure switch switches off the burner
when the working pressure falls below the
minimum value and switches it on again
when it is exceeded.

Start up

Warning
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
Check oil level of the high pressure
Caution
In case of lacteous oil inform Kärcher cus-
tomer service immediately
 Before using for the first time, cut off the
tip of the lid of the oil tank on the water
pump.
 Check oil level in the oil tank.
Do not operate the appliance if the oil level
has fallen below "MIN".
18
pump
 Add oil if required (see technical speci-
fications).
Follow the instructions given in the sec-
tion "Safety Notes"!
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
 Check oil level of the engine.
Do not operate the appliance if the oil level
has fallen below "MIN".
 If required, top up oil carefully.
 Fill fuel tank with diesel.
Caution
Risk of damage to the fuel pump on ac-
count of dry running. Fill up the fuel tank up
to this mark even for cold water operations.
Danger
Risk of explosion! Only refill diesel oil or
light fuel oil. Unsuitable fuels, e.g. petrol,
are not to be used.
 Refill fuel.
 Close tank lock.
 Wipe off spilled fuel.
Install hand spray gun
 Mount the nozzle on the spray pipe
(markings on the adjustment ring at the
top).
 Connect ray tube to hand spray gun
 Connect the high pressure hose to the
high pressure connection point of the
machine.
Installing spare high pressure hose
Figures A-C
 Lever out the safety clip of the hand spray
gun using a screw-driver (Picture A).
 Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
– 4
EN
Motor

Refill fuel