Table of Contents
Advertisement
Quick Links
HDS 801 D
Deutsch
English
Français
Italiano
Nederlands
Español
Português
Dansk
Norsk
Svenska
Suomi
Ελληνικά
Türkçe
Русский
Magyar
Čeština
Slovenščina
Polski
Româneşte
Slovenčina
Hrvatski
Srpski
Български
Eesti
Latviešu
Lietuviškai
59661160
12/13
3
15
27
40
53
65
78
91
103
114
125
137
150
162
176
188
200
211
224
236
248
260
272
285
296
308
Advertisement
Table of Contents
Related Manuals for Kärcher HDS 801 D
Summary of Contents for Kärcher HDS 801 D
- Page 1 HDS 801 D Deutsch English Français Italiano Nederlands Español Português Dansk Norsk Svenska Suomi Ελληνικά Türkçe Русский Magyar Čeština Slovenščina Polski Româneşte Slovenčina Hrvatski Srpski Български Eesti Latviešu Lietuviškai 59661160 12/13...
- Page 2 19 20 12 11 26 14 16...
-
Page 3: Table Of Contents
Please read and comply with Environmental protection these original instructions prior to the initial operation of your appliance and The packaging material can be store them for later use or subsequent own- recycled. Please do not throw ers. the packaging material into Before first start-up it is definitely nec- –... -
Page 4: Device Elements
Water flowing through a system separator Device elements is considered non-drinkable. see cover page Caution 1 Connection for water supply with filter Always connect the system separator to 2 Steering roller with fixed position brake the water supply, never directly to the appli- 3 High pressure connection ance! 4 High pressure hose... -
Page 5: Safety Instructions
The heating appliance of the machine is – Safety instructions an ignition plant. All national laws and regulations about heating systems must Danger also be followed. – Do not use high pressure cleaners when there has been an oil spill; move High pressure hose the appliance to another spot and avoid Danger... -
Page 6: Start Up
Add oil if required (see technical speci- Overflow valve fications). If the hand spray gun is closed, the – Motor overflow valve opens and the high pres- sure pump diverts the water back to the Follow the instructions given in the sec- pump suction side. -
Page 7: Operation
Press the safety clip back into the hand- Connect suction hose (minimum diame- spray gun. The hose can be pulled out ter 3/4“) with filter (accessory) to the max. 1 mm if it has been installed cor- water connection point. rectly. - Page 8 Cleaning Operating with hot water Set pressure/temperature and deter- Danger gent concentration according to the sur- Scalding danger! face to be cleaned. Set thermostat to desired working tem- perature. The burner is switched on. Triple nozzle Operation with detergent ...
-
Page 9: Storage
Secure the hand spray gun using the Interrupting operation safety catch so that it doesn't open ac- Release the lever on the trigger gun. cidentally. Note: When the lever of the hand spray Remove the water inlet hose from the gun is released, the engine continues to run appliance. - Page 10 Motor Maintenance intervals Carry out maintenance tasks to the engine Weekly according to the specifications provided in Clean the sieve in the water connection. the operating instructions of the engine Check oil level of the high pressure manufacturer. pump.
-
Page 11: Troubleshooting
Switch off the appliance and let it stand Top up detergent orset dosing value for for 20 minutes. The hand-spray gun detergent to "0". must remain opened. Detergent dosing valve is leaky. – Then pump out the machine until emp- ... -
Page 12: Warranty
Burner does not start Warranty Temperature limiter has got triggered – The warranty terms published by our com- again. petent sales company are applicable in Get the device checked by Customer each country. We will repair potential fail- Service. ures of the appliance within the warranty Fuel tank empty period free of charge, provided that such... -
Page 13: Ec Declaration Of Conformity En
EC Declaration of Conformity We hereby declare that the machine de- scribed below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. -
Page 14: Technical Specifications
Technical specifications HDS 801 D Type of protection IPX5 Motor Lombardini diesel engine 15LD225, 1 cylinder, 4 stroke Maximum torque at 3600 rpm kW/HP 3,5/4,8 Operating speed 1/min 3300 Water connection Max. feed temperature °C Min. feed volume l/h (l/min) 750 (12,5) Max. - Page 16 http://www.kaercher.com/dealersearch...