Installing The Soundtouch™ Wireless Adapter; Connecting Speakers To The Sa-4 Amplifier - Bose SoundTouch SA-4 Owner's Manual

Setting up the System
Installing the SoundTouch™ wireless adapter
The SoundTouch
™
SA-4 amplifier. It must remain in range of the Wi-Fi
70 feet (21 m) of the SoundTouch
To keep interference to a minimum and to increase the strength of the Wi-Fi
signal, install the wireless adapter outside of and away from metal cabinets,
away from other audio/video components, and away from direct heat sources.
See page 32 for wall mounting instructions.
Note: If you experience interference with your network connection, place
the SoundTouch
and away from metal objects. If problems persist, see "Troubleshooting" on
page 24.

Connecting speakers to the SA-4 amplifier

CAUTIONS:
• Use only unpowered speakers. DO NOT connect any make or model of
powered speakers. Doing so may cause damage to the equipment.
• The SoundTouch
Speaker cables consist of two insulated wires. Often, one wire is marked (striped,
colored, or ribbed), indicating it should be connected to the positive (+) terminal.
The plain wire should be connected to the negative (–) terminal. For recommended
wire sizes and lengths, see "Speaker cable recommendations" on page 27.
1.
Disconnect the SA-4 amplifier from AC (mains) power.
2. Remove the terminal block connector from the SPEAKER OUTPUTS
connector on the rear panel of the SA-4 amplifier.
14 - English
wireless adapter provides the network input for the
controller.
™
wireless adapter outside of any cabinet or enclosure
™
SA-4 amplifier requires a 6-ohm minimum load.
™
router, and within
®