Function Button Setting - Sony LMD-940W Operating Instructions Manual

Submenu Setting
WFM/ALM • WFM: A waveform monitor is
SELECT displayed.
• ALM: An audio level meter is
displayed.
When WFM is selected, the waveform
and audio level are displayed. When
ALM is selected, the audio level is
displayed in eight channels.
The audio levels of WFM or ALM are
displayed when SDI signal is input.
Select the displayed audio level channels
in SDI AUDIO SETTING.
The indications of the waveform (only
when WFM is selected) and audio level
signify as illustrated below, although the
percentage of the waveform, units and
values of the scale for the audio level do
not appear on the display.
When WFM is selected
Waveform
109%
100%
75%
50%
25%
0%
-4%
Channel number
(The channel number which is selected in
SDI AUDIO SETTING is displayed.)
When ALM is selected
Audio level
1 2 3 4 5 6 7 8
Channel number
(Displayed in eight channels, including the channel
which is selected in SDI AUDIO SETTING.)
Audio level
(dB)
OVER
0
-10
-20
-30
-60
1 2
(dB)
OVER
0
-10
-20
-30
-60
Submenu Setting
POSITION Sets the position of the WFM/ALM
display. You can select from among 1 to
4.
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left
TRANSPARENCY Selects from black and half (transparent)
for the background of the WFM/ALM
display.
• BLACK: The background is black.
Displayed image is hidden behind
the background.
• HALF: The background is
transparent. Displayed image can
be seen indistinctly behind the
WFM/ALM display.

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
F 5 B U T T O N :
F 6 B U T T O N :
F 7 B U T T O N :
Submenu Setting
F1 BUTTON to F7 Assigns the function to the function
BUTTON buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE and
WFM/ALM.
Factory setting
• F1 button: BRIGHTNESS
• F2 button: CONTRAST
• F3 button: CHROMA
• F4 button: SCAN
• F5 button: H/V DELAY
• F6 button: VOLUME
• F7 button: I/P MODE
About the function assigned to the
function button
SCAN
Press the button to change the scan size of the picture.
With every press of the button for the 4:3 display, the
picture switches in the sequence NORMAL scan t
OVER scan t NATIVE. With every press of the button
for the 16:9 display, the picture switches in the sequence
NORMAL scan t OVER scan t FULL screen t
NATIVE (see "Scan mode image" on page 24).
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
23
Adjustment Using the Menus