Sony LMD-940W Operating Instructions Manual page 22

Submenu
I/P MODE (picture delay
minimum)
LED BRIGHTNESS
RGB RANGE
MARKER SETTING
USER CONFIG – MARKER SETTING
M A R K E R E N A B L E :
M A R K E R S E L E C T :
C E N T E R M A R K E R :
M A R K E R L E V E L :
M A R K E R M AT :
22
Adjustment Using the Menus
Setting
Selects to set the delay by the
picture processing to the minimum
level when the interlace signal is
input.
• INTER-FIELD: Mode for
giving precedence to the
picture quality. Performs
interpolation depending on
the movement of the images
between the fields. It takes
longer than "FIELD
MERGE" or "LINE
DOUBLER" for processing
the picture. "INTER-
FIELD" is the factory
setting.
• FIELD MERGE: The
processing time is shorter.
Combines the lines in the
odd fields and even fields
alternately regardless of the
movement of images.
Suitable for viewing still
images.
• LINE DOUBLER: The
processing time is shorter.
Performs interpolation by
repeating each line in the
data receiving sequence
regardless of the field. As
the line flicker is displayed
in this mode, it is available
for checking the line flicker
of the telop work and so on.
Sets the brightness of the LED of
the buttons.
• 0: The LED becomes brighter.
• 1: The LED becomes darker.
Sets the black level and white level
for the RGB format of HDMI
signals.
• FULL: 0 (black level) to 255
(white level)
• LIMITED: 16 (black level) to
235 (white level)
xxx
xxx
xx
x
xxx
Submenu Setting
MARKER ENABLE Selects ON to display the marker
and OFF not to display.
Note
When NATIVE is selected in the
SCAN setting, the marker is not
displayed.
To display the marker, select a
setting other than NATIVE.
MARKER SELECT Selects the aspect ratio according to
the film, when the frame of the film
is displayed on the screen.
When 16:9 aspect ratio is selected
with the button which the aspect
function is assigned
When 4:3 aspect ratio is selected
with the button which the aspect
function is assigned
CENTER MARKER Selects ON to display the center
mark of the picture and OFF not to
display.
MARKER LEVEL Sets the luminance to display the
MARKER SELECT and CENTER
MARKER. You can select from
among 1 to 3. When the setting is
low, the marker is displayed dark.
MARKER MAT Selects whether you put mat on the
outside of the marker display.
• OFF: No mat is put.
• HALF: Gray mat is put.
• BLACK: Black mat is put.
WFM/ALM (waveform monitor and audio
level meter) DISPLAY SETTING
USER CONFIG – WFM/ALM DISPLAY SETTING
W F M / A L M :
W F M / A L M S E L E C T :
P O S I T I O N :
T R A N S PA R E N C Y:
Submenu Setting
WFM/ALM Selects ON to display the WFM/ALM
display and OFF not to display.
Note
When the WFM/ALM display is
enabled, the marker display is not
available.
You can select from among
4:3, 15:9, 14:9, 13:9, 1.85:1,
2.35:1, 1.85:1 & 4:3 and
OFF.
You can select 16:9 or OFF.
xx
xxx
x
x