Terminal Panel Features - NEC VT650 User Manual

Terminal Panel Features

1. RGB Input Connector(Mini D-Sub 15 pin)
Connect your PC or other RGB equipment. Use the supplied
signal cable to connect to a PC.
2. RGB Monitor Output Connector (Mini D-Sub 15 pin)
You can use this connector to loop your computer image to an
external monitor from the RGB input source.
3. Audio Input / Output Mini Jack
This is where you connect audio output from your computer.
Or connect additional external speakers here to listen to audio
coming from your Video or S-Video input.
4. Audio Input / Output Connector (RCA)
This is where you connect audio output from a VCR, DVD
player, or laser disc player. Or connect additional external
speakers to listen to audio coming from your RGB source.
NOTE: Either connector 3 or 4 can be used for input or output,
however they cannot both be used for input simultaneously. It
can damage your equipment.
RGB
INPUT
1
OUTPUT
2
PC-CONTROL S-VIDEO
7
E–11
AUDIO
3
IN
OUT
OUT IN
4
VIDEO
5
6
5. Video Input (RCA)
Connect a VCR, DVD player, laser disc player, or document
camera here to project video.
6. S-Video Input Port (Mini DIN 4 Pin)
Connect the S-Video input from an external source like a VCR.
7. PC Control Port (Mini DIN 8 Pin)
Use this port to connect your PC to control your projector.
This enables you to use your PC and serial communication
protocol to control the projector. If you are writing your own
program, typical PC control codes are on page E-45.