Cleaning Or Replacing The Filters - NEC VT650 User Manual

Cleaning or Replacing the Filters

The air-filter sponge keeps the inside of the VT650 Projector
free from dust or dirt and should be cleaned after every 100 hours
of operation (more often in dusty conditions). If the filter is dirty
or clogged, your projector may overheat.
CAUTION
• Turn off the power and unplug the projector before
replacing the filter.
• Only clean the outside of the filter cover with a
vacuum cleaner.
• Do not attempt to operate the projector without a
filter cover.
• Your projector will not operate unless the filter cover
is installed correctly.
To clean the air-filter:
When "Clean Filter" option is turned on, the "Please clean the
filters" message will be displayed each time the projector is turned
on after it has been used in excess of 100 hours. Should this
message appear, clean the filters.
• The message can be turned on or off using the "Menu" - "Fil-
ter Clean Message" option on the Setup menu. See page E-
35.
• After cleaning the filters and resetting the filter usage time
back to zero, the message will not be displayed.
See page E-37 for resetting the filter usage time.
Vacuum the filter-through the filter cover.
R G
IN P B
U T
A U
D
O U
TP
U T
IN
P C O U
-C O
N TR T
O L
S -V
ID E
O
V ID
To replace the air-filter:
1. Remove the filter cover by pushing up on the catch of the
cover until you feel it detach.
2
1
1
2
2. Reinstall the new filter cover.
NOTE: Do not detach the sponge from the filter cover. Do not
wash the filter cover with soap and water. Soap and water will
damage the filter membrane. Before replacing the filter cover,
remove dust and dirt from the projector cabinet. Keep out dust
and during filter replacement.
NOTE: When you replace the lamp, it is also wise to replace the
filters. The filters come in the same package with your replace-
ment lamp.
E–39
R G
IN P B
U T
A U
D
2
O U
TP
U T
IN 1
P C
-C O O U
N TR T
O L
S -V
ID E
O
V ID
1
R G
B
IN P
U T
A U
D
O U
TP
U T
IN
2
P C
-C O O U
N TR T
O L
S -V
ID E
O
V ID