Mounting; Orientation; Rigging; Procedure - Chauvet Epix Drive 900 User Manual

Setup

Mounting

Orientation

Rigging

Procedure

Mounting Diagram
-6-
Before mounting this product, read and follow the Safety Notes. For our CHAUVET
Professional line of mounting clamps, go to http://trusst.com/products/.
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
Chauvet recommends using the following general guidelines when mounting this product.
·
When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
·
The product is not intended for permanent installation.
·
Make sure to mount this product away from any flammable material as indicated in the
Safety Notes.
·
Never mount in places where rain, high humidity, extreme temperature changes, or
restricted ventilation may affect the product.
·
Before deciding on a location, always make sure there is easy access to the product for
maintenance and programming.
·
If hanging this product, make sure that the mounting location can support the product's
weight. See the Technical Specifications for the weight-bearing requirements of this
product.
·
When hanging this product, always secure to a fastening device using a safety cable. For
our CHAUVET Professional line of safety cables, go to http://trusst.com/products/.
·
When mounting the product on the floor, make sure that the product and cables are away
from people and vehicles.
The ÉPIX Drive 900 fits nicely in a standard 19" rack using the included removable rack ears.
You may also choose to attach a M12 mounting clamp for hanging or simply place it on its feet
on a flat level surface. You must supply your own mounting hardware. Make sure all hardware
and mounting surfaces are capable of supporting the weight of this product. For our CHAUVET
Professional line of mounting clamps, go to http://trusst.com/products/.
Rack Mounting
Screw (x4)
Safety Cable
Overhead Mounting
Removable Rack Ear (x2)
Surface Mounting
Rubber Feet (x4)
Mounting Clamp
(Only one needed)
ÉPIX Drive 900 User Manual Rev. 2