Table of Contents
Advertisement
3. S
ETUP
AC Power
AC Plug
Power Linking
Fuse
Replacement
ÉPIX Drive 900 User Manual Rev. 2
Each ÉPIX Drive 900 has an auto-ranging power supply that works with an input voltage range
of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each ÉPIX Drive 900,
refer to the label affixed to the product. You can also refer to the Technical Specifications chart
in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
www.chauvetprofessional.com.
·
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat
or dimmer channel serves only as a 0 to 100% switch.
The ÉPIX Drive 900 comes with a power input cord terminated with a Neutrik® powerCON® A
connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
The ÉPIX Drive 900 supports power linking. You can power link up to 6 products at
120 V; up to 11 at 208 V; or up to 12 at 230 V.
This product comes with a power input cord. Power linking cables are available from Chauvet
for purchase.
1.
Disconnect this product from the power outlet.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove the blown fuse and replace with another fuse of the same type and rating
(T 5 A, 250 V).
4.
Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product's power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
Setup
Screw Color
Yellow or Brass
Silver
Green
-5-
Advertisement
Table of Contents
