Table of Contents
Advertisement
Using the RGB DIGITAL connectors
The Link mode function allows you to adjust or set multiple projectors using the RGB DIGITAL and OPTION connectors.
The DVI DIGITAL input accepts up to the SXGA (1280 x 1024 @75Hz) signal.
NOTE: The Auto Adjust feature does not work for DVI digital signal. When DVI signal is selected and the image position is not corrected, adjust the horizontal and
vertical position using the Position screen. See page E-33 for more details.
Connection for Double or Triple Stacking in Link Mode
Connect source equipment to the master projector.
OUTPUT
INPUT9
RGB
DIGITAL
OPTION
IN
OUT
Master projector
It is recommended that you use a commercially available distribution amplifier if you use signals higher than SXGA (1280 X 1024@75Hz) in Link
mode.
Link Mode
You can daisy-chain up to 16 projectors and operate them separately with the same remote control in wired operation.
Master
Connecting a PC with RGB digital connector
Connect the RGB DIGITAL IN connector of the projector to a digital connector of your computer.
RGB DIGITAL IN connector
OUTPUT
RGB
DIGITAL
OPTION
IN
OUT
Slave projector
Bi-directional RS-232C cable (not supplied)
Slave 1
RGB digital connector
DVI-D cable
(SX6000 only)
DVI-D cable (supplied)
INPUT9
OUTPUT
RGB
DIGITAL
OPTION
Slave projector
E – 24
Master
projector
Slave
projector
Slave
projector
INPUT9
NOTE:
* Use the supplied DVI-D cables for
stacking.
* The end with the ferrite core should
go to the RGB DIGITAL OUTPUT of
IN
the projector.
* Specify the DVI-D type when you buy
DVI cable.
OUT
When you use commercially available
DVI cables, they must be 5 m (16.4
feet) or less in length.
Slave 16
Advertisement
Table of Contents
