Digital Rgb Signal Connection - NEC PA723U User Manual

Digital RGB signal connection

• Connect a commercially available HDMI cable between the computer's HDMI output connector and the projector's
HDMI1 or HDMI2 input connector.
• Connect a commercially available DisplayPort cable between the computer's DisplayPort output connector and
the projector's DisplayPort input connector.
DisplayPort IN
DisplayPort cable (not supplied)
• Select the source name for its appropriate input connector after turning on the projector.
Input connector
HDMI 1 IN
HDMI 2 IN
DisplayPort IN
Cautions when connecting an HDMI cable
• Use a certified High Speed HDMI
Cautions when connecting a DisplayPort cable
• Use a certified DisplayPort cable.
• Depending on the computer, some time may be required until the image is displayed.
• Some DisplayPort cables (commercially available) have locks.
• To disconnect the cable, press the button on the top of the cable's connector, then pull the cable out.
• Power can be supplied to the connecting device from the Display Port input terminal (maximum of 1.65 W). However,
power will not be supplied to the computer.
• When signals from a device that uses a signal converter adapter are connected to the DisplayPort input connector,
in some cases the image may not be displayed.
• When the HDMI output of a computer is connected to the DisplayPort input connector, use a converter (commer-
cially available).
HDMI 1 IN
HDMI 2 IN
INPUT button on the projector
cabinet
1:HDMI 1
2:HDMI 2
3:DisplayPort
Cable or High Speed HDMI
®
144
6. Connecting to Other Equipment
HDMI cable (not supplied)
Button on the remote control
1/HDMI 1
2/HDMI 2
3/DisplayPort
Cable with Ethernet.
®