NEC NP41G User Manual page 73

Settng ID to the Projector [CONTROL ID]
(Avalable only when the optonal remote control NP0RC s used)
You can operate multiple projectors separately and independently with a single remote control that has the CON-
TROL ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projectors
together using the single remote control. To do so, you have to assign an ID number to each projector.
CONTROL ID NUMBER ......Select a number from 1 to 254 you wish to assign to your projector.
CONTROL ID ......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID
ID DISPLAY ........................This option turns on or off the ID number which is displayed when the ID SET button on the
NOTE:
• Selecting [ON] for [CONTROL ID] will make the remote control supplied with the projector inoperable. The buttons on the
projector cabinet can be used. Optional remote control NP01RC does not have the CONTROL ID function and therefore cannot
operate the projector once a Control ID is set.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Con-
trol ID.
• Your setting will not be affected even when [RESET] is done from the menu.
Assgnng or Changng the Control ID
1. turn on the projector.
2. Press the id set button on the remote control (nP02rC).
The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the pro-
jector cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the
inactive projector, assign the control ID used for the projector by using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and holding the id set button on the remote con-
trol (nP02rC).
example:
To assign "3", press the "3" button on the remote control.
No ID means that all the projectors can be operated together with a single remote
control. To set "No ID", enter "000" or press the CLEAR button.
TIP: The range of IDs is from 1 to 254.
4. release the id set button.
The updated CONTROL ID screen will be displayed.
NOTE: The IDs can be cleared in a few days after the batteries are run down or removed.
setting.
remote control is pressed.

. Usng On-Screen Menu
OFF ON
POWER
COMPUTER AUTO ADJ.
1 2 3
VIDEO S-VIDEO COMPONENT HDMI
VIEWER NETWORK PIP
1 2 3
4 5 6
7 8 9
0
CLEAR
ID
MENU EXIT
ENTER
L-CLICK R-CLICK
VOLUME MAGNIFY PAGE
UP
DOWN
PICTURE LAMP MODE ASPECT
AV-MUTE 3D REFORM FREEZE
FOCUS
ID SET LENS SHIFT /ZOOM HELP
ID
OFF ON
POWER
COMPUTER AUTO ADJ.
1 2 3
VIDEO S-VIDEO COMPONENT HDMI
VIEWER NETWORK PIP
1 2 3
4 5 6
7 8 9
0
CLEAR
ID
MENU EXIT
ENTER
L-CLICK R-CLICK
VOLUME PAGE
MAGNIFY
UP
DOWN
PICTURE LAMP MODE ASPECT
AV-MUTE 3D REFORM FREEZE
FOCUS
ID SET LENS SHIFT /ZOOM HELP
ID