NEC NP41G User Manual page 30

Adjust the Tlt Foot
1. lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjust-
ment as it can become heated while the projector is turned on and
during its cool down period after it is turned off.
2. Push up and hold the adjustable tilt foot Button on the front
of the projector to extend the adjustable tilt foot (maximum
height).
3. release the adjustable tilt foot Button to lock the adjustable
tilt foot.
Adjusting the height of a projected image or changing the pro-
jection angle will result in the AUTO KEYSTONE function quickly
correcting the vertical distortion. (→ page 23)
The tilt foot can be extended up to 0.98 inch/25 mm.
There is approximately 10 degrees (up) of adjustment for the front
of the projector.
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
4. rotate the rear foot to the desired height in order to square
the image on the projection surface.
The rear foot height can be adjusted up to 0.16 inch/4 mm (1 de-
gree of angle).
Do not extend the rear foot over 0.16" (4 mm). Doing so will cause
the rear foot to come free off the bottom.
3. Projectng an Image (Basc Operaton)
1
Adjustable Tilt Foot
Rear foot
Up

Adjustable Tilt
Foot Button
2
Ventilation (outlet)
3
C O
M P
U TE
R IN
V ID
E O
IN
S -V
ID E
O IN
A U
D IO
IN
PC
C O
N TR
O L
Down