NEC NP41G User Manual page 56

Troubleshootng on Usng the Bluetooth wreless technology to transmt mages
Problem
Cannot the projector, or
transmission rate is too
slow
Cannot connect to the
projector
Check These Items
®
• Check if the Bluetooth USB adaptor is fully inserted into the USB port of the projector, and make sure that
®
the Bluetooth USB adaptor is displayed in the thumbnail screen. (→ page 46)
• Check if the communication distance is too far or if there is any obstacle between the Bluetooth
tor and your transmission device. The maximum line-of-sight distance is 10 m/33 feet. (*The communica-
tion distance may vary depending on the environment.) (→ page 45)
• Check if the projector is used near a device generating electric wave such as a wireless LAN device or mi-
crowave oven. These devices may cause interference to the radio communications.
• Check if [SEARCH RESPONSE] is turned [ON]. If [SEARCH RESPONSE] is turned [OFF], the search screen
cannot be displayed. Should this happen, turn [SEARCH RESPONSE] to [ON] or specify the BD address in [BD
ADDRESS]. (→ page 42)
• Check if the Bluetooth wireless technology function is turned off with your transmission device. If so, turn it
on.
• Check if two or more transmission devices is sending data to the projector. The projector does not have the
capability of receiving data from multiple devices. Wait until data transmission from another transmission
device is completed.
• Check if a passkey is set on the projector. If so, the passkey is also required to be correctly set on your
transmission device. (→ page 42)
• Check if your transmission device supports the BIP or OPP profile. (→ page 45)
. Usng the Vewer (NP/NP)
7
®
USB adap-