NEC NP41G User Manual page 55

Operatng Procedures
1. turn on the projector.
2. select [VieWer] from the [sOUrCe] menu.
• Another way to select the [VIEWER] source is to press the VIEWER button on the remote control.
• When the slide screen is displayed from the Viewer, press the EXIT button to change it to the thumbnail
screen.
• Make sure that the drive display shows"Bluetooth"on the top left of the thumbnail screen.
3. insert the Bluetooth® UsB adaptor into the UsB port of the projector.
• Insert the Bluetooth® USB adaptor with the [
NOTE: Do not remove the Bluetooth
4. transmit images wirelessly from your Bluetooth computers or mobile phones to the projector
• Select the device name of the projector and enter your passkey on your transmission device.
The default device name of the projector is "BD address of inserted Bluetooth® USB adaptor". The default
passkey is "0000".
• When the projector receives images, those images will be shown on the thumbnail screen.
• If the projector receives unsupported images, the message [FILE FORMAT IS INCORRECT.] will be dis-
played.
5. Use the Viewer of the projector to project images.
• After receiving images, operate the Viewer in the same way as the one for USB memory.
(→ "3. Operating the slide screen" on page 40), (→ "4. Operating the thumbnail screen" on page 40)
• To delete the received images, press the MENU button in the thumbnail screen to select [DELETE...] from
the pop-up menu.
6. finish using the Bluetooth® UsB adaptor.
• Remove the Bluetooth® USB adaptor from the projector.
] side facing upward.
®
USB adaptor while the message [INITIALIZING Bluetooth DEVICE] is being displayed.
C O
M P
U T
E R
IN
V ID
E O
IN
S -V
ID E
O IN
A U
D IO
IN
P C
C O
N T
R O
L
C O
M P
U T
E R
IN
V ID
E O
IN
S -V
ID E
O IN
A U
D IO
IN
P C
C O
N T
R O
L
U S

. Usng the Vewer (NP/NP)
U S
B
B