To Avoid Property Damage, Drain Water From Water Tube; Dispenser Models Loosen Water Tube Clamp Screw. Loosen Plastic - Amana SXD25S2 Service

Kit Instructions
Caution
To avoid property damage, drain water from water
tube into small bucket.
12. Dispenser Models
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Gently pull water tube away
from union nut and through tube clamp.
13. Remove tape from freezer door. Grasp freezer
door securely and lift up while opening. This will
free door from bottom hinge pin. On dispenser
models, plastic water tube must slide through slot
in bottom door hinge as door is raised. Top hinge
will remain attached to door.
14. Remove bottom door trim by removing screws.
When installing HTK200S, HTGK200W,
HTK220S and HTK220W kits, remove door
stops. Confirm support plate is under door trim.
Install new bottom door trim by placing trim on
bottom of doors. Insert screws and tighten.
When installing HTK200S, HTGK200W,
HTK220S and HTK220W kits, install new door
stops by placing door stops on bottom of doors.
Insert screws and tighten.
15. Rehang doors by positioning bottom sockets onto
bottom door hinge pins. Position so doors are
flush with sides of refrigerator cabinet. Handle
side of doors should be approximately 1/8 inch
(3.2 millimeters) higher than hinge side of doors.
Doors will settle when loaded with food. On
dispenser models, when replacing freezer door,
thread water tube through bottom hinge pin and
water tube clamp.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
16. Use masking tape to tape doors shut.
Important
Ensure trim pieces adhere properly by
confirming surfaces are clean, dry and free of
adhesive residue.
Discard factory installed trim and handles.
RS1300003 Rev. 0
17. Replace top hinges by placing top hinges on
refrigerator. Insert screws and tighten. On
dispenser models, reconnect top hinge wire
connectors. Install new top hinge covers by
placing hinge covers over hinges. On dispenser
models, carefully place wires under cover to
avoid pinching wires. Insert screws and tighten.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, green ground wire must be
attached to freezer door hinge.
18. Install new bottom door handle caps by pushing
up into bottom of new handles until caps snap in
place.
19. Install new door handles by placing door handles
on door. Insert screws and tighten. Install new
handle inserts by snapping in place.
20. Remove thin section on top handle end caps to
allow room for panels. Discard section. Replace
top handle end caps by placing end caps on
handles. Insert screws and tighten.
21. Dispenser Models
Replace dispenser cover by snapping in place.
Insert screws and tighten Replace switch by
snapping in place.
22. Install new top door trim by placing trim on top of
doors. Insert screws but do not completely
tighten. When installing HTK200E and HTK220E,
install new color coordinated screws taped to
trim.
23. Dispenser Models
Install new dispenser trim on freezer panels by
sliding trim on bottom edge of upper freezer door
panel and top edge of lower freezer door panel.
24. Slide decorator door panels into place until
panels are secure.
Thin Section
94 December 1997