Wiring Connection; Part List For Installation - Kenwood DPX-5000BT Instruction Manual

Wiring connection

Rear/ Front/ Subwoofer output
For 3-way crossover: Tweeter/
Mid Range/ Woofer output
Antenna terminal
To front speaker (left) / For 3-way
crossover: Mid range speaker (left)
To front speaker (right) / For 3-way
crossover: Mid range speaker (right)
To rear speaker (left) /
For 3-way crossover: Tweeter (left)
To rear speaker (right) /
For 3-way crossover: Tweeter (right)
Car fuse box
Ignition switch
Car fuse box
Battery
To the metallic body or chassis of the car
Fuse (10 A)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
IMPORTANT : We recommend installing the unit with
a commercially available custom wiring harness specific
for your car and leave this job to professionals for your
safety. Consult your car audio dealer.
When connecting to an external amplifier, connect
its ground wire to the car's chassis to avoid damaging
the unit.
Microphone input jack ( 12)
If no connections are made, do not let the wire come out from
the tab.
Brown
To connect the Kenwood
(Mute control wire)
navigation system, refer your
navigation manual
Blue/White
To the power control terminal
(Power control wire/ when using the optional power
Antenna control wire) amplifier or to the antenna
control terminal in the vehicle
Light blue/yellow
To the steering wheel remote
control adapter
(Steering remote
control wire)
Part list for
installation
(A) Trim plate (only for
Toyota car)
(B) Wiring harness
(C) Round head screws
(M5 × 8 mm)
(D) Flat head screws
(M5 × 8 mm)
29
ENGLISH