Basic Operation In The Ohp Mode - NEC DT100 User Manual

■ Basic Operation in the OHP Mode

The functions described here can only be used when your projector is set for OHP use.
NOTE
• In the case of the OHP projection (material projection), there may be distortion more or less because an
ultra-wide lens is used.
1
NOTE
• Though materials can be projected without closing the materials cover, unwanted light, etc., may enter the
scanner, making the projected image more difficult to view.
2
Main control
ZOOM
Remote control
ZOOM
NOTE
The brightness will change slightly if you alter the magnification.
3
Main control
BRIGHTNESS
Remote control
BRIGHT
NOTE
• When the materials or printed matter are nearly black, adjust the brightness to increase, and when they are
nearly white, adjust it to decrease.
1
Open the scanner cover and place the materi-
als to be projected on the scanner.
Close the cover.
Select the magnification.
You can adjust the magnification between 100% and 200%.
Press the left button to reduce the magnification or the right
button to increase the magnification.
Adjust the brightness.
To darken the image, press the button on the left. Conversely,
to lighten the image, press the button on the right.
2, 3, 4
Operation
E-29