Raymarine i50 Installation And Operation Instructions Manual page 21

i50 Speed connection
Item Cable color
1 Brown
2 White
3
Screen
4 Green
5 Red
i50 Tridata connection
1
3
Item Cable color
1 Black (Depth)
2 Blue (Depth)
3
Screen (Depth)
4 Brown (Speed)
5
White (Speed)
6 Screen (Speed)
7 Green (Speed)
8 Red (Speed)
Making transducer connections
Although the transducer cable is fitted with spade connectors for
direct connection to the rear of the unit, it may be necessary to
remove these to facilitate installation, e.g. if the cable has to be
Cables and connections
routed through narrow apertures. 1/8th spade terminals will be
required (not supplied), to replace those removed. When fitting the
new spade connectors, prepare the cables as detailed below:
3 1. Prepare the cable as shown in 1 above.
2. Fold back the wire strands and insert into the new spade
2
1
3. Ensure the wire strands do not extend beyond the rear of the
D12390-1
4. Crimp the connector to the wire.
Signal name
Temperature 0 V
iTC-5 connection
Temperature (signal)
Transducers can be connected to a SeaTalk
Speed 0 V (shield) Raymarine's Instrument transducer converter (iTC-5) and an i70
instrument, the data can then be repeated on an i50 / i60 unit.
Speed (signal)
Speed V+
D12393-1
Signal name
Piezoceramic –
Piezoceramic +
0 V (shield)
1
Temperature 0 V
2
Temperature (signal)
3
Speed 0 V (shield)
4
Speed (signal)
5
Speed V+
6
7
8
Note: Transducers connected to the iTC-5 must be calibrated
using an i70 (master) unit. Transducers connected to the iTC-5
cannot be calibrated using an i50 / i60.
Making iTC-5 transducer connections
For instructions on connecting transducers to your iTC-5 refer to
the iTC-5 handbook.
1
2
connector as shown in 2 above.
spade connector insulation.
1 2
12 V
5
6 7
6 mm
50 mm
ng network using
3 4
8
i50 Depth (Repeater)
i70 Instrument (Master)
i50 Speed (Repeater)
i60 Wind (Repeater)
iTC-5
Depth transducer
Wind vane transducer
Speed transducer
D12359-1
D12033-3
21