Makita 9237CB Technical Information page 14

W
iring diagram for 9237CB
Fig. D-10
Route Lead wires under Switch
as drawn in Fig. 11.
Connector 2-SD
Fix Field lead wire (black) and
Brush holder's lead wire (orange)
in this Lead wire holder.
Fig. D-11
Noise suppressor's lead wires ( 2 pcs.) must be beyond Switch trigger by routing between the ribs and the pin
of Handle set R near the upper side of Switch.
Wiring in Handle set (R)
Noise suppressor (with two Lead wires)
Choke coil
Noise suppressor (with two lead wires)
and Choke coil are put to the place
as drawn above if they are used.
Wiring under Switch
Rib
Pin
15 mm
Come out at least 15 mm long
of Power supply cord from
Strain relief, and clamp the cord
with Strain relief.
Be careful not to put Lead wires
on these ribs.
Route Lead wires under Switch and decentralize
them with the ribs and pins of Housing R.
Strain relief
P 14/ 14
Strain relief