Makita 9237C Instruction Manual
Hide thumbs
Also See for 9237C:
- Instruction manual (29 pages) ,
- Technical information (15 pages) ,
- Instruction manual (29 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita 9237C
Summary of Contents for Makita 9237C
- Page 1 INSTRUCTION MANUAL Polisher 9237C 015677 IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model 9237C Wool pad 180 mm Max. capacities Wool bonnet 180 mm Spindle thread M14 or M16 (country specific) No load speed (n ) / Rated speed (n) 3,200 min Overall length 431 mm Net weight 3.4 kg... -
Page 3: Polisher Safety Warnings
Keep cord away from heat, oil, sharp edges or 19. Do not use the power tool if the switch does moving parts. Damaged or entangled cords not turn it on and off. Any power tool that increase the risk of electric shock. cannot be controlled with the switch is dangerous When operating a power tool outdoors, use an and must be repaired. - Page 4 Do not use accessories which are not Never lay the power tool down until the specifically designed and recommended by accessory has come to a complete stop. The tool manufacturer. Just because the spinning accessory may grab the surface and pull accessory can be attached to your power tool, it the power tool out of your control.
-
Page 5: Functional Description
Additional Safety Warnings: FUNCTIONAL DESCRIPTION 16. Do not leave the tool running. Operate the tool only when hand-held. 17. Check that workpiece properly CAUTION: supported. Always be sure that the tool is switched off and • 18. If working place is extremely hot and humid, unplugged before adjusting or checking function or badly polluted by conductive dust, use a on the tool. - Page 6 To remove the head cover, perform the following steps: Speed adjusting dial Remove the screw on the head cover with screwdriver. 1. Speed adjusting Remove the head cover as shown in the figure. dial To install the head cover, perform the above steps in reverse.
-
Page 7: Operation
For tools which are equipped with a backing pad. Installing or removing the wool pad (optional accessory) 1. Wool pad 2. Sleeve 18 3. Backing pad 4. Spindle 5. Shaft lock 014941 Fit the wool bonnet over the rubber pad. Tie a bow knot and tuck the knot and any loose strings between the wool bonnet and the rubber pad. -
Page 8: Replacing Carbon Brushes
Remove the screw on the dust cover. If you need any assistance for more details regarding Remove the dust cover. these accessories, ask your local Makita Service Center. Wipe the dust cover to remove dirt. Wool bonnet 180 (Hook & loop) •... - Page 12 Makita Corporation www.makita.com 885358A6...