Unit Connectors - Axis Q1602 Installation Manual

AXIS Q1602/Q1604 Network Camera Installation Guide

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet.
CAUTION!
Due to local regulations or the environmental and electrical conditions in which the product is to
be used, a shielded network cable (STP) may be appropriate or required. Network cables that are
routed in outdoor environments or similar shall be shielded (STP) and intended for their specific
use. Make sure that the network switch is properly grounded. See Electromagnetic Compatibility
(EMC) for regulatory requirements
Power connector - 2-pin connector block used for power input.
Function Pin number
GND 1
DC Power 2
Audio in - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used
from a stereo signal).
Audio out - Audio output (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for the audio out.
SDHC memory card slot - A standard or high capacity SD memory card can be used for local
recording with removable storage.
To insert an SD card, lift the SD card cover on the rear of the network camera, and carefully insert
the SD card into its slot.
To remove an SD card lift the cover and gently push the card in and release it.
Description
Ground
Power input 8-20 V DC
SD memory card slot
max 10 W
Page 17
1 2