Adjust Zoom And Focus - Axis Q1602 Installation Manual

AXIS Q1602/Q1604 Network Camera Installation Guide

Adjust zoom and focus

To adjust the zoom and focus follow these instructions:
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive, the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers on the lens by turning them counter-clockwise. Move the
pullers to set zoom and focus and check the quality of the image in the image window.
Note:
If the camera is mounted so that one cannot look at the image and move the pullers at the same
time, use the Focus Assistant instead. See page 14.
5. Re-tighten the zoom and focus pullers.
6. On the Focus page, click Fine-tune focus automatically and wait until the automatic fine-
tuning is completed.
7. Click Enable iris. If the button is inactive, the iris has already been enabled.
8. If needed, make further adjustments under the Advanced tab. See the online help or User's
Manual for more information.
Notes:
• Set focus as precisely as possible with the focus puller or Focus Assistant before starting the automatic
fine-tuning. Using the focus puller normally gives the best result.
• The iris should always be opened to its maximum while focusing; this gives the smallest depth of field
and thus the best conditions for correct focusing.
Status LED
Focus puller
Zoom puller
Control button
Page 13