Foam Marker Kits - Toro REELMASTER 6500 D Quick Service Reference

QUICK SERVICE REFERENCE
Foam Marker Kita
Model 41228
Pro Foam..................................
Pro Foam Concentrate*...............
Filter.........................................
Plastic Check Valve....................
*Note: Concentrate is mixed at 1.25-2.00 ounces per gallon of water.
Daily: Flush the system with clean water after each use, especially when hard water
has been used. Note: Do not apply lubricating oil, grease or other petroleum products
to the compressor motor assembly.
Every 400 hours or yearly:
Winterizing (or extended storage)
1. Relieve the pressure within the tank by pulling the release valve on the tank.
2. Disconnect the air and liquid tubing from the tank cap. Connect the air and water
tubing together with the supplied tubing coupler.
3. Turn on the foam marker for 5 minutes on each side. This will remove solution
from the solenoids and avoid damage.
4. Disassemble the foam nozzles and replace the foam sponges.
5. Empty the tank of all soap and liquids to avoid damage.
IMPORTANT NOTES:
Part numbers, specifications, and lubricants listed herein are subject to change. Refer
to Toro's Master Parts Viewer on the internet at
catalogs. The current version of this document may be found at that website under
Technical Reference section of the Toro Customer Care page. The most current API
Service Grade of oil includes the service properties of earlier classifications. Refer to
the API Motor Oil Guide at the back of this book for further details.
Copyright ® 2004 The Toro Company Rev 03/10
Serial All
41607 (1 gallon container)
41157 (four 1 gallon containers)
94-7227
94-7196
www.toro.com
Page 230 of 258
for online Toro parts