Lcd Keypad (Cs5500) - GE CS5500 Programming Manual

1.2

LCD keypad (CS5500)

The CS5500 LCD keypad allows you to program the CSx75 system using a menu
structure.
Power (green)
Ready (green)
Fire (red)
Function keys
No
The brackets contain the additional digits for 6-digit codes.
•
On if the system is connected to the mains and the battery is OK.
•
Flashes if the system has no battery or a low battery.
•
Off if the system is not connected to the mains.
•
On when the system is ready to arm.
•
Flashes when the system is ready to force arm.
•
Off when the system cannot be armed.
•
On when a fire zone has been activated.
•
Flashes when there is a problem with a fire zone.
•
Off when all fire zones are operating correctly.
•
Press F1 to scroll to the start of the LCD message.
•
Press F3 to scroll to the end of the LCD message.
In multi-area mode, these keys have specific functions. If you select one
or more areas in this mode:
•
Press F1 to part arm the set of areas.
•
Press F2 to full arm the set of areas.
•
Press F3 to disarm the set of areas.
You can program these keys to perform a function when not in multi-
area mode. To do this, select Installer Menu>This Keypad>Function
Keys. For more information on navigating the menus, see page 9.
Press No to:
•
Cancel a change to the menu selection or
•
Navigate to a higher level in the menu structure or
•
Cancel a sequence when entering numeric data.